Locate GPS signal and set time zone for iGS50E / iGS10 Follow
How to ocate GPS signal:
Bike computers will search satellite signals automatically when powering on.
Please stay outdoor and remain stationary when acquiring satellite signals .
Usually it may take 30 to 120 seconds to locate satellite signals.
The time and date will be calibrated automatically after satellite signals are located.
In the whole procedure, keep stationary for more than five minutes outdoors is very necessary. pls double try it and give us a feedback, thanks.
What if the device showed incorrect time?
Pls try to reset the device to the local time zone at the following steps:
Normally, the time will be calibrated on condition that the GPS signal is well located and time zone was correctly calibrated.
Pls set the local time zone in the setting, and the time will be correct when the GPS signal was located.
For example, we are in China, and the time zone will be set to +8:00. and then it the time will calibrate to the current time 10:30 once the GPS signal is well located.
Steps to set time zone:
Default time zone: UTC/GMT+08:00.
Steps:
1) Hold right button more than 2 seconds to enter the setting mode.
2) Select left or right button to change time zone.
3) Hold right button more than 2 seconds to save and exit.
Note: The setting will be automatically saved if no operation in 10 seconds.
GPS is covered all over the world and is free to use.
Comments
0 comments
Please sign in to leave a comment.